About the Bassoon reed case
A tidy case that holds eight bassoon reeds. The insert is printed separately, ideally in TPU, so each slot grips its reed gently. Four small round magnets snap the lid shut. A pause is built into the print profile so you can drop the magnets in mid-print. The reed clip press-fits, though the designer adds a dot of glue so it stays put with daily use.
What you'll need
Printed parts
- Case (PLA or PETG)
- Insert (TPU)
- Reed clip
Bought parts
- 4 × round magnets, 8 × 3 mm
- A dot of glue
Tools
- Nothing
Build overview
Print settings
- Infill: 15–20%
- Layer height: 0.2 mm
- Supports: None
- Magnets: Insert at the built-in pause
Photos
More of the designer's photos are on MakerWorld. See them on MakerWorld ↗